need pics of the harness that goes to the tail lights, the body shop disconect all..
 

well i just pick up my car from the body shop and the guys do a mess up with my interior harness they disconect the tail lights so they can paint the car and now i have a bunch of loose cables in my trunk if somebody has pics of this harness perfectly installed going to the tail light i will apreciate the help. i know is not a big deal but if i see some pics it will be easier.
thanks

i can almost gaurentee your not going to get a picture...

when i last had mine off, they were 3 seperate harnesses, about a foot and a half long. three bulbs on each harness. there should be 2 that look the same(inside and outside light harness) and one thats prob a little shorter(middle harness).

its not that hard. the harness starts the driver door. it runs along the floor/side below the scuff plate and up over the rear wheel arch. you will have stuff like the fuel pump connector which is a short harness with a 4 plug almost square look (2x2) and the other end having 5 plugs 2 larges one in a row and 3 smaller ones below the connector is more rectangular. Basically if you just run the harness along the edge of the car and go around you will the connectors match up..its really not a big deal.

^ he doesnt even have to do that much. when mine was painted all they took out was the main harness that held the bulbs. took about 5 min to hook everything back up

Worst case scenario, the dealer should have a wiring diagram.

All of the RX7 manuals, including wiring diagrams are here:

http://foxed.ca/foxed/index.php?page=rx7manual