need help: knightsports ebs boost controller
 

so i picked up the ebsIV knightsports boost controller used a little while back, and now that i've gotten around to trying to install it - there are a few wires on the harness that have me confuzzled. for any of you guys out there who are using the ebs, your help would be appreciated :)

for the harness there were 3 wires that were cut.
http://www.maj.com/gallery/jrsch22a/rx7sell/wires.jpg
I'm thinking 'B' used to connect with 'C', but they were spliced for some reason by the previous owner...perhaps to tap into some other equipment?

And I don't know what to make of 'A' either ^_^;;

on the other end, there is this connector with the 4 wires which connects to the ebs box. this yellow wire is off on its own.
http://www.maj.com/gallery/jrsch22a/rx7sell/q3.jpg
following the install guide on clubRX for the ebsIII, i think this might be the green 'illumination' wire on the ebsIII version that just needs to be tapped to a 12v for light?

any ideas?
thanks in advance :)

Dale Clark has a review/install guide for that unit I believe http://www.clubrx.org/default.asp?id...ntent=17&mnu=5

V

i did refer to it. but these wires were spliced, it doesnt help me with that part ^^;;

splat.