RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Limp Mode.....?? (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/limp-mode-288235/)

tiger18 03-28-04 10:37 PM

Limp Mode.....??
 
just a quicky,,,,for me to do some research....

what does limp mode feel like,,,,driving i mean,,,
does the car start fine,,,run fine,,,but wont accelerate,,will it let you boost,,,does it misfire,,,or kangarooo,,,,
cheers guys,,,once again,
great site this,,,full of info,,,:)

austinsFD 03-28-04 10:54 PM

kangarooo?
:wtf:

tiger18 03-28-04 10:59 PM

car jumps,,judders=== kangarooo
hahah

iceman4357 03-28-04 11:05 PM

my knock sensor is on the fritz and it goes into limp mode. It doesnt boost as much(7psi). And its much slower

4Fun 03-29-04 12:23 AM

limp home mode is low boost about 8 psi even at WOT

mad_7tist 03-29-04 07:29 AM

it will store a code

MrRx 03-29-04 02:01 PM

pulling off the hose on the *boost* sensor, will cause you car to stay under 5 psi

Enconsiderate 03-29-04 02:06 PM


Originally posted by 4Fun
limp home mode is low boost about 8 psi even at WOT
how do you fix this?

rdavidsrx7 03-29-04 02:14 PM

Guess it depends on the code, because when my OMP went out my car would bog as soon as I got to 5in/mg. It would basicaly refuse to gointo boost at all.

ChrisChung125 03-29-04 07:50 PM

try disconnecting the battery and holding down the brake for 15-20 sec.

Fatman0203 03-29-04 08:02 PM


Originally posted by rdavidsrx7
Guess it depends on the code, because when my OMP went out my car would bog as soon as I got to 5in/mg. It would basicaly refuse to gointo boost at all.
This is exactly what happen to mine couldnt go over 3k.
Then I did the battery off and hold brake and fixed it.

seanfd3s 03-29-04 08:24 PM

the ecu might have sizzed up? bad idel,dies at idel low boost?

tiger18 03-29-04 09:23 PM

my ECU is giving the code for faulty oil metering pump sensor,,,,so looks like,,ill have to rip it out and see what i can do with it

SWAT81 03-30-04 12:02 AM

did you guys know that the word kangaroo originates from Australia? When the pioneers first made contact with the natives there they asked what those animals were jumping around, and the natives said "kangaroo" which means "we dont know" in their language. Interesting right? ROFL

SWAT81 03-30-04 12:06 AM


Originally posted by ChrisChung125
try disconnecting the battery and holding down the brake for 15-20 sec.
this reboots the ECU correct? I'm pushing about 5~8 psi of boost so I'm assuming I'm one of the victims of LIMP mode as well? I also did a vacuum hose job few weeks ago as well as coolant hose job yet I feel as though I'm getting a boost leak. Any harm from doing this reset if it isn't the LIMP mode?

rdavidsrx7 03-30-04 11:02 AM

tiger18,
check the wires going to it first, somehow mine just got clipped by the main pulley cutting the red wire. Tape and a connector solved my prob.

Swat81,
Nah no harm in doing it....and very interesting fact, thanks, but how do Aboriginees say "I don't know"?

arutha 03-30-04 11:34 AM

My limp mode experience is that the car "kangaroos" when I push on the accelerator too far. Does it at any RPMs, not limited to 3k and higher, and pretty much forces me to drive slow, which I assume is the intended purpose.

SWAT81 03-31-04 12:39 PM

it boggs for me when I aceelerate hard so I guess I am in LIMP mode and didn't realize it, I will try resetting the ECU since I haven't done those since some minor mods.

rdavidsrx7 03-31-04 01:44 PM

yep, limp mode, but how do they say "I don't know"?
hahaha


All times are GMT -5. The time now is 01:22 AM.


© 2024 MH Sub I, LLC dba Internet Brands