RX7Club.com - Mazda RX7 Forum - Labor on Installation of Jimlab Bushings?

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)

- 3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)

- - Labor on Installation of Jimlab Bushings? (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/labor-installation-jimlab-bushings-279640/)

Louis M

03-06-04 12:43 PM

Labor on Installation of Jimlab Bushings?

What would this reasonably be?

Louis M

03-07-04 08:23 AM

bump

xchaos

03-07-04 08:25 AM

It would vary by shop/location. Maybe 10 hours, so $650-700, then you need an alignment.

POM HB

03-07-04 01:20 PM

Really that much? Better do it ourselves then.

jimlab

03-07-04 03:12 PM

The Mazda "special service tool" (SST) for intalling and removing bushings is about $300, IIRC. A good 12- to 20-ton shop press is about $150-200, and then you'll need a good selection of sockets for pressing (and pressing into) arrangements. :)

All times are GMT -5. The time now is 03:29 PM.