JDM Motor?
 

Hey Guys,
Will a JDM shortblock (motor only).. swap into a US Spec FD without issue.
I know you can't do a full engine swap due to the wiring harness being on the opposite side. So.. just the motor only.

Thanks Guys... Stoked to finally have my FD back and running after 6 months!

I believe so.

Yes.

good info, didn't know that about the wiring harness - how about ecu? transmission?

You can use a JDM wiring harness. My car has a full JDM front clip transplant including the harness/ecu/etc... The previous owner did the swap so I can't give you any details about how it was done, but it's doable.

great info, thanks

Just finished wiring a Jspec engine for a customer last week. It's not drop in and go you'll have to modify the X-05 and X-14 connectors if I remember correctly. With that, you'll also have to pop all the pins out of the one harness and re-pin them to the correct fashion.

If you want to buy a Jspec motor and use a US spec harness you're good to go. Using the Jspec harness requires attention and you might find broken wires and shorts in the harness to repair like I did. The job took several days to pinpoint and repair the wires and in one case I had to run a new brown/white wire to the TPS, OMP, and MAP sensor.

I'll I'm saying is be ready to expect the unexpected.

Just the shortblock will drop right in.
A longblock needs harness mods.