ISO: Mock-Up 20B for Short-Term Fab
 

Hi All,
Bit different/random request - Looking for an empty 20B for mockup purposes during the fabrication portion of my project to avoid using my built/recently coated setup. Anyone know if any services exist to avoid buying another 20B?

Any help is greatly appreciated

you could, knowing the thickness of the housings, make suitable spacers and use old 13B housings.

Allthread and plywood is your friend.

I would just use the engine you have. How is mockup going to hurt it?

Thanks all for the suggestions. I figure it was a shot in the dark but wanted to see if anything existed as some transmission Mfr's offers mockup units for a nominal deposit amount and is returned once its shipped back.

Just wanted to limit the possibility of ruining of the finish, But i agree its likely to be fine.