installing the stock wiring harness
Anyone have any pointers on installing the stock harness. I'm to the point where the rats nest is going down and I just can't get shyt to fit together.
I searched, but couldn't find what I was looking for? |
Assuming you're replacing you harness with a new one, take lots of pictures with a digital camera if possible. label the connectors with numbers and masking tape. As far as the rats nats goes. I would just go non-sequential and be done with it.
|
This is where the mechanics get seperated from the want-a-bees.
Intuition and skill are required here. |
Originally Posted by slo
Anyone have any pointers on installing the stock harness. I'm to the point where the rats nest is going down and I just can't get shyt to fit together.
I searched, but couldn't find what I was looking for? The FSM has the wiring harness routing in a diagram. I've posted a JPEG of the image here before but the search function is waiting on the forum upgrades to find it. :) |
I had some fun fitting the harness in the area where it passes around the LIM and across the injectors.
These should help: https://www.rx7club.com/showthread.p...arness+routing https://www.rx7club.com/3rd-generation-specific-1993-2002-16/fpd-fuel-pulsation-dampner-replacement-%2A-write-up-%2A-549019/#post6700794 Take your time, don't break anything. |
Thanks, I havn't broken anything, yes its a new harness, to late to mark everything but thats not an issue, I know where all the plugs, um plug into.
Its made harder by the fact that I wrapped the entire harness with heat tape, making it a good 2mm thiker, everywhere. I am a decent mecanic/fabricator this is just something I shouldn't have tackled at midnight after 8 corona's. But no harm done and thaks for the links. |
Its too early for Cinco de Maio, mang. Lay off the Coronas for a couple more days :)
Give a shout if you need a hand. I'm local. |
All times are GMT -5. The time now is 11:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands