Installing car alarm, c-lock HELP
 

How do i connect my alarm to open/close locks?

My alarm wants to be connected with 2 wires, positive/negative (my choise) and one wire is to lock and the other one to unlock.

Does the driver side have a lock motor?

PLEASE HELP!!!

i would like to know that 2 i have the same problem i'm searching for the lock and unlock wire to complete my viper alarm... so my doors lock when i arm the alarm.

Sorry guys I took my alarm in to get it installed, all i remember is they had to put some different kind of actuator in the door underneath the window controls and now it sits up a bit, from what they said the factory thing wouldn't work right with the door unlock/locks. I have a Clifford pager alarm.

yes, the driver side door DOES NOT have an actuator built it, so you will need to get an aftermarket actuator installed, or you will have to get a JDM passenger side (our driver side) door latch assembly, because all passenger side FD doors have an actuator within the latch assembly, this is because it "mimics" the driver's side, as in if driver's side is locked, the pass. side will lock and vice versa.

i recently did this install over winterbreak and it is a pretty rough job...from what i remember:

1. you have to somewhat "trick" the factory alarm or trigger the factory alarm to go on/off when you lock/unlock the doors
2. find a place to mount the aftermarket actuator OR remove the stock lock assembly and replace it with a JDM passenger side one
3. run 2 wires through the door harness into the driver's side footwell (PITA)

thats all i remember right now