Idle Control ?
I'm trying to figure out an idle problem and I was wondering if anyone knew what I should have electrically at the plug for the idle air control motor. Any help would be appreciated.
Thanks, Todd |
The idle speed control solenoid is a "duty cycle" solenoid, you'd need a oscilloscope to accurately test the input.
If you just want to know if it working, jump the ten and gnd in the diagnosis connector and the idle speed should change. ( the ISC is disabled ) What symptoms are you experiencing? |
Well I have an AEM ecu and I can't get the IAC motor to respond so I was trying to figure out what I should have at the plug to figure out if my problem is in my wiring or what.
Todd |
Your above my paygrade there sorry.
|
Thank's anyway's
Todd
|
Is the black and white wire on it just a ground? I'm a retard when it comes to wiring diagram's
|
the b/w wire is 12v from the EGI relay, 12v when the key is on
|
Thank's man that's what I thought but wasn't really sure. I think I might have screwed my harness up when taking the extra stuff out. If it's just 12v I can just run a separate wire then right?
|
All times are GMT -5. The time now is 12:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands