RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   I think I am an idiot (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/i-think-i-am-idiot-98432/)

trigeek37 07-21-02 10:21 PM

I think I am an idiot
 
last thrusday I switched my plugs for the first time since owning my fd. I was having problems all weekend with hesitation at 5000 rpm or so, and thought it was my fuel issue, and I just took it really easy on the car all weekend. I am now pretty sure that I switched the bottom two plug wires. I have been told that you can run w/o these plugs on, thought probably not a smart thing to do.... this makes sence yes?

and yes, I am an idiot!
:)

rx7even 07-21-02 10:54 PM

:withstupi

Haha, well I'm not sure if you mixed them up or not, but your bottom plugs are your leading (main) plugs, the top ones are the trailing (more or less emissions plugs). If you WERE going to run without 2, it'd be the top two, wouldnt recommend it with the bottom ones. :) I'm too tired to think and tell you which wire should go where. I'm sure someone else will think for me.

trigeek37 07-21-02 11:05 PM

hmmm....

maybe that is not the cause for my new found lack of power....
would someone be so kind as to post a pic/drawing of the plug diagram so I can check? that would be fantastic!

also, if it isn't this, anyone have any other ideas? it is new since I replaced my plugs....

Dimcorner 07-21-02 11:08 PM

I believe the leading plugs fire at same time so it wouldn't matter if you switch the bottom 2.

trigeek37 07-21-02 11:26 PM

what if I mixed up the top two?
I was hoping this was my problem.... cause I don't know where to go if this isn't it.

Mahjik 07-21-02 11:30 PM

This thread should help:

https://www.rx7club.com/forum/showth...threadid=90833

Dimcorner 07-22-02 10:59 AM


Originally posted by trigeek37
what if I mixed up the top two?
I was hoping this was my problem.... cause I don't know where to go if this isn't it.

They both go to same coil so they fire at same time so it don't matter where they go... It might matter because the cable might be better positioned one way, but I don't think it would make a difference if they were swapped.

trigeek37 07-22-02 11:27 AM

ok....
could going with NGK 9s all around with my setup be causing the huge hesitation at 5000 rpm?

my mods:
PFS SMIC
PFS ECU
PFS intake
PFS dp
RB cat back
efini y-pipe

Dimcorner 07-22-02 12:48 PM

put the old ones back and see what happens then. I mean you could just swap the wires back and forth (much easier than removing plugs), but maybe one the the wires are not in all the way. Give it a try and let us know.


All times are GMT -5. The time now is 05:28 PM.


© 2024 MH Sub I, LLC dba Internet Brands