help: engine harness
 

question on the where two cables on the engine wire harness go, i cant seem to find where they go to theres no open cables nearby, and in this diagram it looks like its just hanging there

By any chance do you have pictures of the actual connectors? I can't tell which connectors they are through the diagram.

Hard to tell from that diagram (the clarity is like poo) but that appears to be the alt/starter/battery harness in blue.

Based on that, perhaps a connector goes to the oil pressure sending unit? Other one not sure. More pics def needed.

its dark out, ill take some pictures tomorrow

As already mentioned, it's tough to tell from that diagram...

If that's near the power steering pump then one of them goes to a power steering pressure switch in the power steering system, and the other goes to the thermostat housing... I think it's the thermoswitch but check the wire color and look for that color combination in the factory wiring manual.

hope these pics help :)

I believe the white connector is for the A/C pump. Someone correct me if i'm wrong, but the black connector looks like the coolant level disconnect.

are you thinking its this one? cause there is a very similar connector that i have already plugged into the ac condenser

the one with the arrrow on the bottom of your first diagram is the oil level sensor u can find the wire colors and location on page z42 and z43 of the wiring diagram the sensor is in the side of the oil pan. still searching for your other plug

the white plug's wire is black white a red stripe and
the black plug's wire is brown with a white stripe

does this look right?

sorry guys im retarded this cable was connected to the wrong one you guys were right the white goes to the compressor

https://www.rx7club.com/attachment.p...1&d=1253944217

haha, just got them switched. Happens all the time.

thanks for all the help and input guys :)