has anyone had bad bearings in a remanufactured engine
 

Fellas, make sure when you do an engine swap that you make sure your oil pan and oil cooler is flushed out. I purchased an engine from Atkins rotary, it lasted about 30 minutes before the bearings were in the oil pan. I believe that the bearings were not properly installed, but Atkins says that it was oil contaminants, and if it happens again they will not cover it. I know that my oil cooler and oil pan was clean, but i cannot prove that. Atkins REPAIRED the engine, but im scared that it will happen again. does anyone have any ideas?

>>>>>

well in this case you can't win. You say your pan/lines/cooler were clean... and they say they were not. You also can't prove that there was anything wrong with the internals of the engine since you never saw them. :(

Brian