Greddy fmic without cutting bumper: possible?
 

Did someone manage to achieve this miracle?

It depends on which front bumper. A little info would help?

I was able to fit it with a C-West bumper and it looks like it would fit an RE-A one too.

Stock 1993.

I seriously doubt it. That kit requires a LOT of hacking to install. They tried to make the kit real flashy with the front mount way up front so you see it. I have the Blitz front mount and have had the Apexi in the past, both of those kits don't require hacking (very minimal) and you can't see the front mount in the car without getting down and looking.

MAYBE the kit could be bought and a lot of re-engineering could be done to make it fit without cutting, but at that point don't buy a kit.

There's a reason that kit is so cheap. I'm not a fan of it at all.

Dale

No, you will have trim the stock bumper.

Bumper and support both have to be cut.

https://cimg9.ibsrv.net/gimg/www.rx7...302a84af14.jpg

Blitz does not require cutting of the bumper


https://cimg1.ibsrv.net/gimg/www.rx7...dd111576cb.jpg


https://cimg3.ibsrv.net/gimg/www.rx7...eaf82e26c6.jpg