gm 3 bar map sensor
 

I recently purchased a gm 3 bar and i was curious if anyone here has done this to their FD and what I need to do tio install it and have iot work??/ thanks for the help...feel free to email any help as well jackshiz468@gmail.com

Did you search?

Lots of people have installed GM 3 bars, you need a Power FC and access to a datalogit to change the Map sensor settings. If you did not buy our Sensor and Adapter kit, then you are going to need a pigtail to change out the connector.

yes i searched but i was un-sure of whether or not i needed a datalogit to make it work....so a datalogit is necessary??

Yup - you will need to calibrate the ECU to the sensor and only the Datalogit will allow you to do that. You could always borrow one to do this - the Datalogit does not need to be present after calibration.

yes you need some way to calibrate it ie .12344 volts = 1.5 psi 4.7579 volts = 27.754 psi etc. just made up those numbers

and i do have a pigtail connector, but no directions on what goes where....guess i could figure it out tho

call any RX-7 shop i know plenty of people that would help you on the install, if it goes un answered in the next few days ill go home and take pics of mine for you.

So what are the actual numbers?

+1 Please and thank you.

give you guys the spots for the wires when i get home tonite if u still need them???