RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   FInding the right mechanic (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/finding-right-mechanic-142633/)

Lazerblu 12-21-02 07:27 PM

FInding the right mechanic
 
I brought my 93 to the dealer becasue of a fuel smell. Turns out the injectors o-rings and the fuel rail needed to be replcaed. The dealer wanted $2000.00. What a rip off.

I took it to M2 Performance and it only cost $950 and that included changing my vacumn hoses with their parts so they don't pop off like the stock ones.

Since I had it in the shop I asked them to check the ACT clutch and that had to be replaced but once the transmission was out, they found the needle bearing not working and my crank shaft floating around.

Even though I got a hell of a deal $14,000 for a 93 with 59,000 miles. I still had to shell out $3000.00. Damn it that it happens this time of year. Anyway I want to give major props to M2 Performance for doing what they did for my car. I would recommend anyone in the area to use them as a shop. They know their shiznit!!!:D

btytc 12-21-02 07:32 PM

Too bad I'm on the other coast....It's hard to find someone who is honest and know what is doing.....

Lazerblu 12-21-02 07:56 PM

That is soo true. The cool part is that they started changing small parts that needed to be replaced but didn't charge me. They actually felt bad that they found the needle bearing problem because it was and additional $1000. If you have questions you can always call them for advise. Mike and Brian over there are very cool and down to earth.

keynote22 12-21-02 09:26 PM

Been there........dealer in Indy gave me a huge list of stuff causing my oils leaks and a huge bill. Shane at Aim said it was just the oil pan and fixed it without pulling the motor--way less money. He even discovered that the dealer had all the air box hoses hooked up wrong so he fixed that and to top it off he was concerened that some of my lines weren't fastened down properly so he zipp tied everything up nice and tidey. he stayed way late to install my dp on a friday night. The next morning my check engine light comes on so he comes in on Saturday--a day off-- to help me diagnos the prob--the factory connector was toast. I wish I needed more work to get done cause this guy and his team are what good service is all about. If you are reading and need a shop, support companies like AIM and M2 Performance.
http://aimtuning.com

btytc 12-21-02 09:26 PM

I would not feel right to just call them since I am so far
and could not give them any business.......
I can do pretty much everything myself,but sometimes you get into situation that you just can not solve it and that's where it would get handy.....

BATMAN 12-21-02 11:20 PM

anyone good in miami, FL other than pettit ( expensive. ) and Dragon motorsports. ?

shmaLbus 12-21-02 11:37 PM

any good places on the middle of the easter coast (around nj)? it'd be nice to have a place to turn to if something fails that i cannot fix or don't have time to fix.

only place i know of is KD Rotary but they are backed up for months.

btytc 12-22-02 06:42 AM

Ya,Ryan,(Don't be a Rikky) but he is in South MD ,wery cool guy,wery knowledgable.......

RonKMiller 12-22-02 08:46 AM

For $24.95, you can get a subscription to www.alldatadiy.com.

You would be amazed how easy it is to work on your car with the right information. It's what the pros use.

Disclaimer: I have not subscribed for my 3rd gen so I have no idea how good it is for this vehicle - but it has saved me thousands of dollars on other vehicles I own over the past several years.:D

btytc 12-22-02 12:03 PM

Yes Alldata is very helpfull ,if you keep your 7 stock
once you start modifications in some cases it does not apply,(vac.simplification,fuel syst......)
But still,I use it ,mostly for troubleshooting electrical problems.

Lazerblu 12-27-02 10:51 PM

Well got my ride back tonight. It feels like a different car in a great way. Turns out the following had to be done and was under $2600.00 parts and labor.

Replaced fuel injectors
NEw o-rings
New M2 Clutch
New needle bearing
New fuel hoses kit
New Pulsation damper
New Oil level sensor o-ring
New Metering pump o-ring
New M2 boost couplers
Replaced oil level sensor

These guys know their shiznit. My car rides soooo different. Smooth and when the turbos kit in, damn....

It you are in the area and need a shop you can trust...call M2Performance 925-686-9055 or 925-685-7534.

scratchjunkie 12-27-02 11:23 PM

right on lazer, im happy your satisfied with your business with m2. gotta love em'

Lazerblu 12-27-02 11:48 PM

Thanks man...I already have plans to have the M2 Stage 2 upgrade done, includes

Reprogram ECU
Downpipe
3" Cat bach Exhaust
M2 Cold Air Intake

Along with an intercooler upgrade.

scratchjunkie 12-28-02 12:48 AM

sweet...i wish it were sunny in the bay though...i havent ran my 2nd turbo in a while =/

ROTARYFDTT 12-28-02 05:22 AM


Originally posted by keynote22
Been there........dealer in Indy gave me a huge list of stuff causing my oils leaks and a huge bill. Shane at Aim said it was just the oil pan and fixed it without pulling the motor--way less money. He even discovered that the dealer had all the air box hoses hooked up wrong so he fixed that and to top it off he was concerened that some of my lines weren't fastened down properly so he zipp tied everything up nice and tidey. he stayed way late to install my dp on a friday night. The next morning my check engine light comes on so he comes in on Saturday--a day off-- to help me diagnos the prob--the factory connector was toast. I wish I needed more work to get done cause this guy and his team are what good service is all about. If you are reading and need a shop, support companies like AIM and M2 Performance.
http://aimtuning.com

I will also vouch for Shane and AIM, I've had my car there twice and both times they were really great. Worked extra hard to get me back on the road when I came down there to pick it up, and I greatly appreciate it. Hey, tell them Ryan from Detroit says hi and thanks a ton next time you are in there. Great shop and guys working there as well.

Lazerblu 12-28-02 01:03 PM

Scratchjunkie.... where you at in the Bay? I live in the far east bay but work in South City.

scratchjunkie 12-28-02 01:58 PM

im 10 mins from m2....

Lazerblu 12-28-02 08:50 PM

Right on...I'm in Disco Bay.


All times are GMT -5. The time now is 09:50 AM.


© 2024 MH Sub I, LLC dba Internet Brands