A few questions before i put it all back together
 

ok so i took my engine apart in order to rebuild it ,
before i put it all back together i just need to make sure of a couple of things in regards to "accesories" and other junk around the engine
Btw im rebuilding using Atkins master kit ( including thermal pallet)

i have a JDM fd3s btw

here are some " reliability mods i want to undertake while im at this stage of the game , plz by all means , bring to my attention anything you thing it`s important to know about anything mentioned below :

- waste gate porting
- emission removal ( air pump and all the rest , i have all the BOP`s from Banzai)
i want to remove ALL unnecessary solenoids and keep sequential ( any tips appreciated )
- HKS 3" downpipe & wrap it
- stock cat for now
- OMP mod ( oil source will be external ( 2 cycle synthetic )
- FPD Removal ... i rememebr i was supposed to tap some kind of adapter .. what is it again ?:Wconfused :)
- simplify what is left of the sequential system
- replace all hoses
- remove P.S. and all lines related to it
- Keep A.C.
- install greddy elbow + piping for SMIC + pulley kit ,
any other thing that should be done at this point ??

thx :icon_tup:

thx for the link

*It's not etched in stone that with emissions removal you must have it, but you may want to consider a PFC.
*Up-grade the stock OMP lines.
*Clean and flow-test your injectors.
*An oil pan brace.