FC Center Iron Vs FD Center Iron
Hi guys,
Is there a difference between the FD center iron and the FC center iron? Moe Greene |
yes. the important one is that the intake ports are in a different place
|
Originally Posted by j9fd3s
(Post 12220252)
yes. the important one is that the intake ports are in a different place
|
This shows the end irons, but the port difference and placement is significant.
https://www.rx7club.com/rotary-car-p...-boost-966709/ Easiest would be to compare to the iron that you have in pictures. It should be pretty obvious based on the port design. Dale |
Most distinctive feature of the FD center side housing to me as an FC guy is that the FD housing has a big rectangular groove/slot above the intake ports' face and below the LIM center bolt hole for the injector air bleed feed and the FC just has 2 little holes alongside the LIM center bolt hole for the bleeds.
https://cimg2.ibsrv.net/gimg/www.rx7...59c2e2fe9c.jpg |
huge differencehttps://cimg8.ibsrv.net/gimg/www.rx7...017a19e809.jpg
|
Do NA FCs not even have the center lower intake manifold bolt?
I never noticed that, but it sure explains why almost all the Holley 4150 style intake manifolds lack provision for the center bolt... |
correct. no bolt.
|
Thanks everyone! This was extremely helpful! Now I can finish my rebuild and hopefully drive again.
|
All times are GMT -5. The time now is 05:03 AM. |
© 2024 MH Sub I, LLC dba Internet Brands