error code 3
 

when i try starting my car.....my airbag light gives me 3 short flashes (my car is a stock 1998 j-spec) so no CEL light on the dashboard.......i have read that the error code 3 is for crank angle G sensor.......if this sensor isnt working will the car start??.......when i crank it seems that it almost wants to start......then i see the flashes on the dashboard while trying to crank. Can someone please tell me what this sensor does?? and if its not working will my car start??
Thanks
Tahmid

Priority | Flash Code | Cause/Diagnosis

1 | Remains on | Faulty Diagnostic Module or Poor Connection at Diagnostic Module

2 | Flashes 3 times | Open Circuit Or Poor Connection Of Power Source Circuit

3 | Flashes 5 times | Faulty Front Impact Sensor

4 | Flashes 10 times | Faulty Diagnostic Module Due To Open System-Down Fuse

5 | Flashes 4 times | Faulty Rear Safing Sensor

6 | Flashes 6 times | Faulty Air Bag Module Or Poor Connection At Clockspring

7 | Flashes 9 times | Open Circuit Between Diagnostic Module And Front Impact Sensor

N/A | Remains Off | Damaged Warning Light Circuit

check the connectors.

anyone know if the airbag light will flash codes the same as a usdm cel will. do you ground the same terminals as we do in the us? hopefully someone from over seas will help

thanks for the reply......abt the same gnd and ten.....i'm not 100% sure but it seems like it......my codes give out when i try and start the car......i hope that soemone from the overseas help me out here.......

that is the crank signal the g sensor fwiw. i would look at the wiring near it and also the connectors. sometimes the crank will chew the wires if the get loose.