Ducting for Greddy SMIC?
 

I am looking to buy the Greddy SMIC and am looking for a quality duct. Does any one make one specifically for this? Are there any alternatives?

Many people make their own. Some buy a duct that matches pretty well from Pettit. There is nothing specifically made for it.

Might be something your interested in......
------> https://www.rx7club.com/showthread.php?t=620241

Thanks... Actually I am involved with that thread and hope it works out.

I bought two (my son and I both has 93s) and they work great, made of welded aluminum and the fitment while not absolutely perfect, it nearly is. I bought them from Rx7_Nut13b here on the forum.

I bought two (my son and I both has 93s) and they work great, made of welded aluminum and the fitment while not absolutely perfect, it nearly is. I bought them from Rx7_Nut13b here on the forum. I have the XS Power SMIC not the Greddy.

Which ones did you buy? Are either hooked up to a Greddy?

I haven't seen one where the lower connection is a welded on 90 degree elbow before...

That is great as it addresses a real issue with these ICs (the piping hitting the front pulley)- but it would have been nice to have a bead rolled or welded onto the end as well. Not to mention it would have been great to be underwear free.

-edit- related thread strikes again