RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Drive belt broke and damaged cable (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/drive-belt-broke-damaged-cable-1009114/)

unreal-icarus 08-21-12 01:46 PM

Drive belt broke and damaged cable
 
Hi, my drive belt literally exploded (the one that uses the p/s pulley and the a/c compressor pulley) and tore apart one (i hope its only one) big wire. Can you identify this wire? it is beneath the left most pulley near the airbox. heres a pic:

http://www10.pic-upload.de/21.08.12/n28n86utsvg.jpg

thanks for help, could'nt find it in the manual.

cewrx7r1 08-21-12 03:11 PM

Does not matter what it is used for.
(1) Disconnect the battery.
(2) Remove surrounding parts so that you have access to the wire.
(3) Repair the wire.
(4) Re-install battery.
(5) Set up a maintenance schedule so that you will periodically inspect YOUR car for problems before they become serious as this was. This could have been prevented!

unreal-icarus 08-22-12 12:45 PM

This happened unexpected. my car is really well maintained... will bring the car to mazda tomorrow, would be nice if anybody could identify the wire.

CloudPump 08-22-12 01:36 PM

You shouldn't need to identify the wire to repair it. Or for that matter should you need the Stealership.

Disconnect your battery.
Find each end of the broken wire.
Solder wires together.
Wrap in Electrical tape.

Enjoy car.

-Geoff

cewrx7r1 08-22-12 11:31 PM

The closest harness is the MOP as it goes just behind and below that area.

scotty305 08-23-12 09:59 AM

As mentioned by the chuck, that does look like the oil metering pump wires, there are about 7 or 8 of them in that bundle. They are wrapped in a distinctive covering that looks different than most of the other harnesses on the car.

Sorry this happened to you but thanks for posting about it... it's probably time to change the belts on my car.

unreal-icarus 08-24-12 02:41 PM

i just had a look at my car and the connectors. the cables were ripped out of the metering oil pump connector (B1-40). the problem is the outgoing color codes in the manual match the colors of the cables that are in my car, but the incoming cables dont. B1-40 is a 10 pin connector with one empty pin, so 9 cables are coming in. i have 9, 3 directly out of the engine (blue, black, yellow) an 6 coming from another connector (blue, red/white, black, yellow, white, red) next to them. can you identify these cables? Outgoing colors are as stated in the manual: brown/white, green/black, brown/black, black/orange, blck/blue, white/black, white/black, black/light green, black/yellow.

Since the colors dont match, im not sure where to put them. i need the pin configuration of the 6pin connector and the 3 pin connector (in case there is one) of the 3 cables.

http://www10.pic-upload.de/24.08.12/aqoi7uxuq72e.jpg

okevin 08-24-12 02:46 PM

i agree with the other people, checked my car around that area, looks like its coming from the OMP

CloudPump 08-24-12 02:53 PM

Your problem might be the manual you're looking at.

I see your car is a 99 FD. They may have changed a lot of the colours of the wires if you're looking at the easily accesible 93-94 online manuals.

-Geoff

unreal-icarus 08-25-12 02:48 AM

in the wiring diagram, theres only one side of the omp connector. i looked twice, cant find the opposite site. Yes, the wire colors are different on both sides of this connector.

unreal-icarus 08-26-12 05:01 AM

Anybody? i really need help with this.
for better comprehension i painted the following picture. What i need is to know if theres anything i am missing in my wiring (the big ?) and if not what the pin configurations of the 3, 6 and 10 pin connector are. even if your wiring colors dont match mine, i could resemble mine because i would know from where to where each wire goes (for example 3pin connector: left top to 10pin connector bottom right)

http://www10.pic-upload.de/26.08.12/1di18x5cysfb.png

Derex'7 08-27-12 12:44 PM

If thats how your omp wiring schematic looks then its the same as the 93-95 model years...Im looking for this same info as my omp conncector was ripped off now car is in limp mode and need the diagram to wire it back correctly

unreal-icarus 08-28-12 01:20 AM

the wire colors are different modelwise

ACCR 08-31-12 07:02 AM

Hi, I have 99 Type R Imported from Japan with Mikuni OMP. Hope this will help you...

BLACK/YELLOW - WHITE 6P
BLACK/WHITE - ORANGE 6P
BLACK/BLUE - BLACK 6P
BLACK/GREEN - BLUE 6P
BLACK/WHITE - RED 6P
BLACK/ORANGE - YELLOW 6P

BROWN/BLACK - BLACK 3P
GREEN/BLACK - YELLOW 3P
BROWN/WHITE - RED 3P

http://s4.mojalbum.com/9476664_17594...7/19997350.jpg
http://s4.mojalbum.com/9476664_17594...7/19997351.jpg
http://s4.mojalbum.com/9476664_17594...7/20005593.jpg
http://s4.mojalbum.com/9476664_17594...7/20005594.jpg

CloudPump 08-31-12 07:18 AM

Good old Slovenians to the rescue. I love Slovenians, I went to school with a bunch of them, great people ;)

-Geoff


All times are GMT -5. The time now is 09:34 PM.


© 2024 MH Sub I, LLC dba Internet Brands