DIY Digital Compression Tester
...found and interesting thread on another forum..
DIY Digital Compression Tester http://www.illstreet.com/forums/show...9552#post39552 sometimes the server is really slow... |
I've thought about this many times before...
Making a DIY compression gauge would be pretty danged simple. All it takes is a sensor, a fitting/adapter, a DAQ card, and a laptop. I already have a DAQ card and laptop (pretty nice and flexible USB DAQ cards could be had for ~$100). Digikey has adequate sensors for pretty cheap (much less than the $103 one this guy was looking at). A little time at the lathe would give me a plug-to-sensor adapter. Voila! Hasta, Shad |
very c0ol
eric e |
Kick Ass! I'm all up in that!!! I've been wanting a Mazda compression tester for a while, and this is much cheaper :).
Thanks! Dale |
Where do you get the software??????
|
I believe the data acquisition unit comes with the software. Could be mistaken.
BTW, the pressure transducer is an Ametek P207. It's in stock at various other places, but for $190 or more. Ack! I might have to see if our local Grainger stocks that part. Dale |
i currently run something similar to a digital compression tester and there may be some crossover....
i log exhaust manifold pressure EMP (backpressure). that'd be between the engine and the turbine. i use a Honeywell Pressure Sensor Monolithic Signal Conditioned. 4000PC Series catalog number 4040PC150G4D w Packard connector or G5D w leadwires. i bought and use 2 of them (fuel pressure logger) on Ebay for $40 total. as to logging/recording pressures digitally............. they key is to have lots of samples per second as the compression is dynamically always changing and your sample only reads for a very small time period. i see this as i review my EMP readings. granted the engine will be cranking at only approx 250 rpm which helps a bit. the sensor runs off 5 volts so you can get a feed from, your MAP sensor if you wish. probably an easy thing to make. howard coleman |
I recently built one and it works well.
http://i3.photobucket.com/albums/y94/Gadd/rearcold.jpg I got the inspiration from Fdjunkie’s thread; https://www.rx7club.com/showthread.p...1&page=1&pp=15 The wave pattern shows a small “wiggle” at the valley, is this from the ports opening and closing or from the shape of the chamber? |
https://www.rx7club.com/forum/showth...44#post4748244
Here is a Pressure Transducer for Sale to build your own tester under 100 dollars |
oh man I gotta build one too
|
All times are GMT -5. The time now is 01:36 AM. |
© 2024 MH Sub I, LLC dba Internet Brands