Cusco Rear Strut Bar
 

Does anyone know if the strut caps will fit over a cusco rear strut bar without any modification?

Someones gotta have one of these installed ....

Are you talking about the covers?

Yes.

They're pretty tight.....I think you may need to remove some material for it to work. One of mine fit ok, but the passenger side one cracked when I put it on.

Just be careful when you put them back and remove material as needed.

Thanks for the info, I had the very same question.

I have one installed but i'm looking for the covers to just clean up the back a bit.

http://i26.photobucket.com/albums/c1...ca_gt/6460.jpg

Thanks for the info. Does anyone have pics with the covers?

Someone has to have these installed with the covers? Pics please.

Ok...took some pics:

I have one of theres installed with the covers back on also. Worked fine for me.

No modifications at all? Thanks,:icon_tup:

Perfect. Just what I was looking for. Thanks.

Not that I can recall....it was a while ago I put it on and dont have the car near to check, but I remember it being tight....dont think I had to modify it at all though.

are these actually stronger than the stock one or just bling factor?

I dont even know why I still have it. I have a bar of my roll cage welded to the strut towers.

Wanted to get a consensus on this before ordering one...is it confirmed that a Cusco carbon fiber rear tower bar will not require cutting/modification of the stock panels?

Worst case you'd have to cut into the 2 top caps to make it fit. If you're really paranoid about it get a used set and cut those up. They are a dime a dozen.

Dale

Confirmed. Installed one on a cherry low-mile CYM not long ago and it was plug-n-play :bubrub:

Great! Thanks Rich.