Coil Relocation Install Question
 

Followed the install notes and mounted coils as stated (T1 by strut tower, leading, T2 by firewall). Fished harness from coils under brake fluid reservoir (most direct path) and I cut one zip-tie holding connection to wiring harness. It is still short. There is a rather firm ring holding the wiring bundle and harness in place and it appears I will need to cut into this to get the necessary slack. No one else having this issue? Charlies7 has been very responsive in answering questions but I was curious if I was the only one having this difficulty. It is a '93 base.

Could you link me to the install notes? I bought the same bracket and have no install instructions. Which spark plug wires are you using?

Its just a ring clip that holds it right there. I just pulled a little and it came off and gave me all the slack i needed.

Chris

Can't find the install thread I used earlier. Only thing it really gives you is the sequence for mounting the coils and ignitor; easy enough to figure out by the mounting holes and the way the harness lies. I bought the wires from Charlie7 with the bracket.

I clipped the ring clamp and my harness is still too short. For whatever reason my wiring harness is short (no comments please). Decided to solve the problem by getting the HKS twin power amp.