which clutch to buy?
 

i want to replace my clutch while the motor is out and need some advice on which one to get?street ported motor going in,ic,intake,dp,mp,cb are mods.thanks for any info.

you will be best off with an ACT Street/Strip. while you are at it, get a lighter flywheel at the same time.

ya get the act street/strip not the 6 puck.. and get a lighten flywheel its worth it!

i was thinking about the light flywheel.what do i lose by going with a light one compared to a stock one?

I think with the lightweight flywheel you lose torque...

I agree ACT street/strip clutch. It is not any harder to push down on than stock and clamps much better. With the lightened flywheel, it is a little easier to stall the engine when starting off in 1st. And the car will start to lurch if you let the rpms get much under 2k. But the up side of the flywheel more than make up for it.

PM me or email me at QuinnCapit@aol.com if you are interested in a ACT clutch.

Mark

I say go with the Cusco single plate clutch. I don't know anyone who has it yet. You'll be unique in the USA and I've read it performs really good too. Not hard to drive and I think it cost a little bit more then the ACT. It's no where near the price of my Mazdaspeed twin plate.