broke rear tranny mounts on motor
i was putting my tranny back on my motor and as i was tighting them they snaped off the rear rotor housing mounts any suggestions
|
There are no rear tranny mounts on the engine.
There are two engine mounts that attach to the rear rotor housing. Each is held on by 3 bolts to the housing and 1 nut to the subframe. Try again in ENGLISH to describe what you hosed. |
Originally posted by cewrx7r1 There are no rear tranny mounts on the engine. There are two engine mounts that attach to the rear rotor housing. Each is held on by 3 bolts to the housing and 1 nut to the subframe. Try again in ENGLISH to describe what you hosed. |
bingo u got it, i guess thats wut i get for using air tools and not my head
|
My mechanic was given this problem by a customer . He welded the broken part, tab.ear, back on with a nicad rod . The engine was installed and was good to go . No problem to the water seals from the heat ,he did something to protect from heat damage . The engine was together when the repair was done .
|
Has the piece or ear broken off yet? Overrev... Try giving Garfinkle a call if Duboisr will hook you up with a #...Ask him about what he used to weld( I know she said Nicad rod) But ask anyways how he protected against heat. Thanks Duboisr for telling about the similar problem, I never heard this happen before. ..
Man overev, you must have had a HUGE impact gun to snapoff those ears!!!!:D ;) |
yep i broke three of the little basterds off before i decided to leave it alone and go inside. (Bad temper with stuff like that)
|
Originally posted by BigIslandSevens . .. Man overev, you must have had a HUGE impact gun to snapoff those ears!!!!:D ;) Yea i dont play when it comes to my tools, snapon 550 ft of torge at 90 psi, my compresser is set a 150, i like all the power i can get |
Pshhh... 1000 ft-lbs of torque on my bad boy....but how the fuck did you get air tools even NEAR those things. I scratched up my forearm just getting a wrench into those tight spots.
|
had the motor and tranny out, and was bolting the tranny back and the damn pilot bearing was crooked, couldn't figure out why my tranny wouldnt go on so i broke out the impact, and bam snap them off! still put it back in though ill drive it like that until l can get it fixed.
|
All times are GMT -5. The time now is 08:13 PM. |
© 2024 MH Sub I, LLC dba Internet Brands