after vacume line replacment car stalls?
The car was running ok before I replaced the vac lines. But I was getting no boost 5psi at max. The car idels fine but when you rev the engine it hesitates and bogs down and if I try to drive it stalls.
What did I do wrong? I tried searching but dont know where to start. Checked all selonoids and pass valves and followed the diagram And felt very positive about the job. My lower manafold dosent have a egr valve on it but I did have the selonoid so I capped it off. Could that be it? It also has a clicking sound by the plenum that wasnt there before. Thanks for any help Im sure you can tell that Im new |
I have good vacume at idel about 17psi at 1000 rpm. But stalls when I give it gas?
|
completly stock just a new ast
|
Have you started troubleshooting using Section F of the FSM yet? TPS or a problem with the MAP sensor would be first guess.
|
Wow 17 pounds per square inch @ 1000 rpms!!! What a torque curve huh?!!
|
Thanks Ill start there. The map sensor broke and I glued it. Not so good I guess
|
Not when you can get a used MAP for $40.
|
Originally Posted by corymarc.com
Thanks Ill start there. The map sensor broke and I glued it. Not so good I guess
This might explain why it at least idles well, I'd say your pressure reading won't work well with it cracked and you should look for a used one in the parts for sale/wanted section for 3rd gens or call Ray Crowe up and get a new one, who knows you may have done the job correctly but won't know till it's fixed. |
All times are GMT -5. The time now is 12:34 PM. |
© 2024 MH Sub I, LLC dba Internet Brands