300 rwhp on sequential?
 

I've read so much about it's easy to get 300whp on stock turbo's with 12 PSI but is this only on Non-seq? or is it possible on seq aswell?

It's hard to find anything when searching.

Horsepower figures change very very little when going from seq to non-seq. 300 rwhp is definitely attainable on seq twins, I don't know if it's doable at 12 psi, but you can probably get really close.

I have 300 at 10.5 psi on stock sequential turbos.

There are 370 plus rwhp cars that run sequential...

"I have 300 at 10.5 psi on stock sequential turbos."

What mods do you have? I wan't to get to at least 300 this summer but i don't want to change the turbos out yet

That's good to know.

Thanks.

Check out his web-page in his sig. It's really good.

I had about 320rwhp at 12psi. Soon to be upped to 375 (at a higher boost level though).

downpipe, midpipe, exhaust, ecu, intake would give you 300hp for sure with stock twins.

301rwhp with 12psi on primary and 13psi on secondary.

DP, CB, CAI, ECU.

i've got DP,intake highflowcat at the moment.

I was going to go single but think i'm changing my mind about that.

I don't really need much Hp cause im only interested to drive on a track.

292rwhp @ .7bar
310rwhp @ .9bar
sequentially

twins
 

333 rwhp at .94 bar.

intake, DP, MP, CB, 850 primaries, RP fuel pump, power FC, jacobs rotary propack, Greddy SMIC,

I've been told you can see close to 400 rwhp with the Efini twins. I also thought about single turbo, but $$ and the lag have kept me from it.

G

i've always thought to get 360+ on sequential you'd have to port the motor?

Downpipe, SMIC, Catback, Intake, PFC tuned to 12psi gave me 290rwhp safely.

:wave: 370.9 rwhp, on sequential Japan spec Type RS twins @ 16 psi

yep

Re: 300 rwhp on sequential?
 

i wouldnt call it easy. i have 294.7rwhp conservatively @ 12psi.

my mods are dp, cb, intake, fmic, microtech, ported motor, and fresh turbos.

steve prew

my mods dynoed at 300 rwhp on a heat soaked engine (60 deg cel intake temps) at 13.5 psi tuned conservatively...

prew, you should be gettin' more than that...talk to your tuner.

i know. my motor just blew after 1k miles too. awesome!

My warranty is up in 10 days, and i just got my radiator replaced for free, so now starts the engine moding, *with an evil sounding he he he after*

304rwhp and 280lb/ft of torque at 13psi. Greddy FMIC, PFC, Greddy intake, pulleys, DP, Bonez hiflo cat and Greddy exhaust.

Sorry, I am on the cars original sequential twins.

i squeezed out 301rwhp (301 or 307, can't remembebr) at 10psi with the mods listed here.

www.apneablue.com/rx7