RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)

- 2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)

- - wiring harnes (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/wiring-harnes-222979/)

pinkfloyd

09-11-03 11:54 PM

wiring harnes

i need a wiring harnes for a 1988 rx7 that was n/a but now has a t2 motor. dose it matter weather it is a t2 or a na for the harnes... also the engine is a jdm. dose that matter eather...thanks

Icemark

09-12-03 12:26 AM

You would need a T2 engine harness if you have the turbo motor now installed.

DAN CARWIN

09-12-03 04:58 PM

pink floyd, go back to your original post on the engine. do research on the harness and JDM motor b4 assembly I responded to the harness 4 you. if it is a n/a to a T2 you will need the map sensor, you will need to switch out the battery harness as well for the cac, and starter.

pinkfloyd

09-12-03 11:26 PM

i have to switch out all the wires anyway.....there was a fire and every peice of plastic was melted

All times are GMT -5. The time now is 08:34 PM.