UIM gasket
Any tricks for removing the UIM gasket?
|
Warm it up and use a nice scraper or razor. Just be careful not to gouge the soft metal. If its really hard, Permatex makes an spray on gasket remover. It makes a mess of things though
|
i also used a fine sand paper once I was done to make sure that the new gasket went on smooth and didn't bubble. Vac leaks between the manifolds are just a huge waste of time so make sure you are thourough! and good luck
|
All times are GMT -5. The time now is 08:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands