Turn-signal cancelling hub?
 

Hey Guys,

I'm looking for a hub assembly that would allow turn-signal cancelling. I had a hub in another one of my FCs, but it wasn't cancellable, and most of the time I would forget to cancel the turn because my loud ass exhaust would muffle the turn noise.

So does anyone have experience with a hub that has turn signal cancelling?

NRG? Momo?

Also, looking for a quick release. Any recommendations?

Thanks for the help.

The turn signal sensor has two prongs that fit into my Momo hub, and are used for turn signal cancelling (and in my case the power steering and AAS). Did you trim them off when you had your other hub?

Also did you tighten the hub down 'til you heard a slight crunch? I had to replace my turn-cancel sensor when I did that -- it wouldn't cancel anymore.

I didn't put the hub on, on the other FC. It was on there from a previous owner. I didn't notice it until like 3 weeks later when someone told me my blinkers were on =P

Replace the turn signal canceling cam assembly?

I'm just saying, some of the steering wheel hubs eliminate the turn signal cancelling. Which ones retain it?

Momo and Grant have the holes for cancelling.

Would the NRG release fit on top of the momo hub? and where can I get a genuine momo hub? not an ebay replica.

Would the NRG release and the momo hub keep the steering wheel relatively close to the turn signal switch? I do know that the steering wheel could get so long that you'd have to reach out to get to the switch. I'm looking for something that might possibly be shorter or in the stock position with the release.

Thanks for all the help so far =D