Turbo II rear end swap into GX
 

Hello,

I tried searching for this on here and Google, but I'm not finding detailed info. I was wondering if there exists a guide with pics on how to swap a Turbo II rear end into a 1990 GX. I'm about to pick up a rear end with calipers all around for $250.

I'm sure it won't be too difficult to figure out as it should (in theory) bolt up using the reverse process of removing the old setup. It would still be nice to see it online first though.

Thanks,


- Roger

do you have a NA tranny? if so you are going to need a custom driveshaft. you will also need the turbo axels.

Yeah I have an NA motor and tranny. I plan to do a Trubo II engine swap later on. The drive shaft from the T2 won't bolt up to the na tranny?

I don't think so, doesn't mazdatrix sell a custom shaft that mates the two? or is that TII tranny to n/a rear end?