TPS voltage with SAFC-II
OK i've searched and searched and found a few answers but i'm not sure what is right. I know that you should adjust your tps using the LED or OHM method, but i have niehter but do have a safc. I can read the voltage of the tps. Currently I have around .98 at 0% and 4.505 at 100%. I found that .99 should be the corrects volatage at 0%. Is this right? Anyone with a properly adjusted tps and a safc could you read yours and tell me. Thanks
|
when fully warm yes.
|
Repeat of the above: yes one volt. But don't worry about it varying on either side .05 or so. Your FSM say approx 1 volt at idle with a fully warmed up auto. You missed that??
|
All times are GMT -5. The time now is 02:49 AM. |
© 2024 MH Sub I, LLC dba Internet Brands