Suggestions for 90 degree elbow pipe
 

Hey all,

So got a slight issue, need to get a 90 degree elbow joint to stick the air filter on the turbo. Needs to be 4.5 inch diameter, which isn't a problem to find already got picked up the K&N Filter today.

But since it won't fit, need to get the elbow joint to point it toward the battery. Any suggestions on what to use as material?

I've heard pvc pipes would work fine, but others have told me the housing still gets super hot, and pvc won't cut it. I suppose aluminium would be the best, anyone know a good place in Calgary, AB to get this kinda stuff?

http://members.shaw.ca/typh00n/rx710.jpg

thanks
Gee

You need a pipe that has a 4.5" OD ..... good lord how big is that filter?

Heh its not so bad.

About 10 inches long, and then 5 inch diameter, cylinder shaped is the only way I could go.

:cool:
Gee

or one of those dirt cheap ricer Ebay vendors. its just a pipe, so i dont think they can screw that up too much.

Im nto sure about the 90degree pipe thing, btu I just wanted to comment on that very interesting IC piping you have going there.