RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Stuck plug on transmission (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/stuck-plug-transmission-296086/)

den 04-18-04 10:45 AM

Stuck plug on transmission
 
I'm in the middle of changing the oil in the transmission but the fill plug will not budge. Would it be o.k to use the check hole plug to fill it back up ?

den 04-18-04 06:35 PM

Bump !

WAYNE88N/A 04-18-04 06:42 PM

I would think so, but then again I only have two plugs on mine, so what do I know? If you can put the quantity in that the manual calls for, then why not?

JunpoweR 04-20-04 04:24 AM

u can remove it
I just swaped a tranny into a s5 and it was a bitch to get off but use some strength or mabey a breaker i used a 14 crascent wrench and used another to break it
longer the bar easier remember so try it out make an extension somehow use ur brains i did =)


If its still too hard for your weak ass J\K
use a torch and heat it up mbey that will help but remember it will be hot!!

RXSevenSymphonies 04-20-04 05:11 AM

Mine was stuck too. Just use plenty of PB Blaster + Crescent Wrench + Cheater Bar and it should come loose.

Project84 04-20-04 08:31 AM

Probably goes without saying now, but the unwritten (well, maybe it is written) rule is that you remove the fill plug first, then the drain plug. If you can't get the fill plug off, then at least their is still fluid in the tranny and you can still operate the vehicle safely. Draining the fluid just to find out that you can't get the fill plug out makes life harder.

Tofuball 04-20-04 09:21 AM

^ Tru

Mine was also tough to get to. I used a lot of PB Blaster and let it sit for a bit, came back and smacked it around and blasted it a bit more, then attached my breaker bar to it and put a long, long pipe (cheater bar) at the end of that, and with a loud CRACK it came out. You gotta really try, but it will come!


All times are GMT -5. The time now is 09:12 AM.


© 2024 MH Sub I, LLC dba Internet Brands