RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   s5 acceleration problem (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/s5-acceleration-problem-1045858/)

RotaryPoisonStar 09-10-13 07:55 AM

s5 acceleration problem
 
Hey guys I have 1990 s5 NA and I'm having an issue. My car spits and sputters and has no power at lower rpms. I have to rev up to 4grand plus just to move it. When I put my foot into the pedal she stalls out. I've tried replacing mass air flow sensor and my next is the tps. Anyone got any ideas? I also just had new exhaust gaskets put in. Any info into this would help greatly. Thanks in advance.

inflatablepets 09-10-13 12:12 PM

MIL codes? Vacuum leaks? TPS adjusted correctly? MOP failure?

RotaryPoisonStar 09-10-13 05:08 PM

I checked the mass air flow sensor. What is mop? I have check engine light on but no one 1 scanner to read the codes. I've been checking for vac leaks but haven't found any yet. Again thanks for your help.

satch 09-10-13 05:13 PM

Metering Oil Pump.

RX7 FD & Series 5 Error Codes

RotaryPoisonStar 09-10-13 05:18 PM

MOP could cause the engine not to want to accelerate at low rpms? Crazy thing is it does the the 3500 cold start perfectly and then idles down to 750. However when I pulled the air filter and pushed in the maf sensor the motor dies.

RotaryPoisonStar 09-10-13 05:21 PM

Thank you for that link I'll check out the ecu tomorrow.

marclong 09-10-13 06:34 PM

Limp mode

RotaryPoisonStar 09-10-13 07:17 PM

How do I get it out of limp mode?

88fc3sT2 09-10-13 08:32 PM

There's a CEL Decoding method somewhere on here. I'd check that out first. It could also be your TPS as mentioned above.

satch 09-10-13 09:28 PM


Originally Posted by RotaryPoisonStar (Post 11570239)
How do I get it out of limp mode?

You need to verify that you are in linp mode to start with. If this is your problem then you likely need to replace the OMP and perhaps the ECU as well or you could rechip your ECU and premix as an alternative.

Molotovman 09-10-13 09:29 PM

It is most likely the OMP/MOP.

It will start and idle fine but die as soon as you put it under load. Perform the tests in the FSM for the OMP. You can download an FSM with the FAQ. I can sell you a 6or 7 year old OMP with low mileage on it for $700, or you can buy a 22+ year old one for +-$50 in the parts section. You should also put in a good used ECU with it. OMP is known to take out the ECU, and then the bad ECU takes out the new OMP. You can open it up and look for two bad resistors.

RotaryPoisonStar 09-10-13 09:46 PM

hmm I actually have an s5vturbo rtek ecu. could I get away with disconnecting that pump and premixing? by disconnecting that pump will it alow me to drive my car?

Molotovman 09-11-13 09:59 AM

Please search, you're asking questions that ave been answered many times over. Also, there's more than 1 type of RTek.


All times are GMT -5. The time now is 12:39 AM.


© 2024 MH Sub I, LLC dba Internet Brands