RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Question about fuel:air mixture (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/question-about-fuel-air-mixture-75359/)

pip 04-29-02 12:35 AM

Question about fuel:air mixture
 
If I am worried about running to lean or to rich, what is a good way to check/correct these problems? Would it be a good idea to invest in an s-afc or something similar?

Ranzo 04-29-02 12:45 AM

The best way to check is to get a wideband O2 sensor and a good Air/fuel gauge. This will tell you the parts of air to fuel ratio.

There are many ways to change the fuel/air ratio. A S-AFC would be a good way to adjust this.

pip 04-29-02 12:52 AM

OK thx for the advice, where would I purchase a wideband O2 sensor and a good Air/fuel gauge?

Scott 89t2 04-29-02 12:57 AM

the wide band 02 is around $1000. you don't buy one. you find a shop that has one and pay to use it.

but I can bet you are running too much boost and too lean from your mods. before you do anything else and before you floor your car again buy a boost gauge. if it goes over 10psi LET OFF!. next buy a bigger fuel pump. that'll keep it safe to around 10psi. but I bet you are hitting 15.

pip 04-29-02 01:00 AM

I am hitting about 10 psi even(aftermarket gauge), but one of my friends who is a mechanic said he thought my FC was running rich. Thx for being nice to a noob :) But you guys always make me so damn nervous bout my baby :)

pip 04-29-02 01:04 AM

BTW scott are you running the same exhaust as me? If so did it mess up your air/fuel mixture?

Ryde _Or_Die 04-29-02 02:25 AM

You could possibly be running rich in low rpms but not where it counts, top end. I haven't gotten any real power mods yet myself for fear of blowing my engine.

pip 04-29-02 12:25 PM

alright my walbro fuel pump is now in the mail and the FC is in state of perpetual parkedness until it arrives :) Hopefully not to late....

Ryde _Or_Die 04-29-02 12:28 PM

Ya I just got my walbro in. Got to install it along with my gauges and my fuel filter. Think a DP/MP might be next on the list and then the s-afc.


All times are GMT -5. The time now is 12:53 PM.


© 2024 MH Sub I, LLC dba Internet Brands