problem hooking up O2 sensor
 

my O2 sensor is good for nothing except plugging a hole in the headers. while working on the engine i noticed a wire that looks like it was cut. My guess is that it went to the O2 sensor. the stock connector probably wouldn't reach the O2 sensor on the headers (because the sensor location is further back than stock) so the wire was cut when the headers were installed (before I aquired the car). just a guess.

Is there any way I can reconnect the O2 sensor or should I just not worry about it?

I have the same question. I simply cut and extended mine when I installed the racing beat header. But I threw a code for the O2 sensor ever now and again.

i have mine spliced and it works fine

where can i get the connector for the sensor?

just use a spade connector thats what i used