Port matching intake manifold help
 

Just asking if these look okay? Port matching for the first time and just wanna make sure they look full. Still gotta stand it down and all that jazz ik.
https://cimg1.ibsrv.net/gimg/www.rx7...77dc5be081.jpg
https://cimg3.ibsrv.net/gimg/www.rx7...3bc91508ce.jpg
https://cimg7.ibsrv.net/gimg/www.rx7...ed05cd7463.jpg

Doesn't look like you ported anything. Only thing I see out of the ordinary is gooped up gray stuff in a couple of spots...
The pics are kinda fuzzy.

It might be the camera angle, but the JB Weld doesn't look very well mixed.

Check with a light to make sure that the colour is uniform all the way across.

it's the lighting. I'm finished and have it all sanded down now so I think its good

I'm very confused as to what's happening here. as gracer7-rx7 mentioned, it doens't look like you've done any porting. Is the intent to fill those and port to use on a 6port NA engine like this?

I'm doing a 6-port build. i was mainly asking if it looked full. The porting hasnt been done yet, I just wanted to make sure it was full. It's all clarified now, as I finished it up on my own