newb to rotor engine.....i really need some help.
ok so i got my first rotary motor 4 days ago :bigthumb:.....its a 1988 13b 6port FI engine. i bought the motor complete.
now the help i will need from all you. i also will be searching elsewhere.....joined other forums......been surfing for 4 days not so much yet......... hopefully this forum will kick some ass. so far in the recent searches i found here looks like we got alot of rotary gurus on here.....hope you can help. i know i can convert this motor to the old reliable :blue: WEBER carburetors (51mm IDA's) :blue: and swap into my VW........looking to get the manifold from rotary shack...have the kennedy adapter kit. anyways i would like to know about what i should do regarding the following: stock Oil metering pump(can i ditch it)......crank sensor(can i use a distributor from an old model)..... BASICALLY: what i can get rid of what to keep and what i need to get to have this motor running. any info will be truly appreciated. any special company or engine builder i can contact? thanks again, mario |
you can ditch the oil metering pump if you run pre-mix..supposidly
|
ditch everything, get a buncha block off plates to block off everything, run premix ( 1 oz per gallon) and run a distributor.
|
What they mean by "premix" is adding 2stroke motor oil to your gas. In case you didnt know. Welcome to Wankel land.
|
All times are GMT -5. The time now is 11:44 PM. |
© 2024 MH Sub I, LLC dba Internet Brands