my car wont start!!!!!!!help!!!!!!!
 

well i have an 88 turbo car i bought a 89 jspec turbo and i havning trouble trying to get the starter to work i have all the wire hooked up under the dash right but i dont know about the wires from the batt. hooked up right.... everything works but my starter and i just got a brand new one i had it tested before i left the store and so i just need to know if i need to doing anything like is there a good way to check the wires....i dont have a meter to check so it has to be getto..ha ha

That picture is Wicked small.... Bump to the top.

thats as big as i can make it

Hey make sure all the clips that come in through the dash are plugged up. There are two up near the hole that if they aren't plugged in no starty..... be positive that they are plugged in. Later Tater

jspec.
did you check compresson on the rotars?
take out plugs. and hand crank or turn the key to crank over the engine. listen for 3 solid wooshes(from both rotars) if one seal is busted you'll here 2 soft woosh and one strong woosh. if you here this........ well..........
50% of the time jspec are blown or seals are rusted

ps. is the safty switch behind the clutch connected? there is a grounding switch. you have a switch there so your car wont turn on if your clutch isnt down. make sure you hooked that switch up. it completes the circuit to your starter ^_~

thats it for what i know...

Do the screwdriver trick. Put the screwdriver across the connections on the starter. She'll turnover if you got power and a good ground. Then you'll know the problem is in the clutch safety switch or the ignition switch.

His problem is that the starter won't kick out not the engine (yet). The motor appears to have some compression even on all faces. But it's a wiring issue at this point.

well i think i have all the wires pulled up but i can double check that dash..... i will keep trying everything that i can think of and what you tell me..... i need my car running!!!!

When he turns the key one of the relays up front clicks... So we can pretty much rule out the ignition switch... Is there a way to bypass the clutch switch to see if it is suspect?

Also, MAKE 100% sure that the two relays under the coil closest to the firewall are plugged up as on of them is the "starter cut" relay according to the FSM. I would go back and 100% check all the connections.

You could bypass the "clutch" switch and see if it is bad by just using a spare connector (thin one that clips to the top of the solienoid) and plugging the stripped end into the other "hot" wire on the starter... Also try regrounding the damn thing.