Well guys I am going to be installing the motor in a hour or so, and I am making sure that I have everything hooked up properly. When I did this I noticed that the little nipple/tube on teh intermediate housing has nothing going to it. So where does this go?
Thanks
-Justin

 

Is it on the drivers side next to the knock sensor? If so, its part of the positive crankcase ventilitation system (PCV) and needs to be properly routed to a non pressurized source.

 

So basically just put a tube on it and route it to atmosphere?
And just to make sure its right next to the tube on the oil filler neck that goes to the vacum harness.

 

I think some people route it into a catch can.

 

Yeah your supposed to route it to a catch can but I think most just open vent it.

 

Yep I have mine to the Cusco catch but you can just run a vacuum line down the side fender opening.

 

Do you have a link or pic of this?

 

I cant host pictures.......

If someone else can, let me know and I'll email after work (22:00PST)

 

Just stick a hose on the nipple, run it down under the car somewhere and cable tie it to something. All you're doing is venting the sump outside engine bay instead of in it.