Just replaced Oil Pedestal O-Rings! Props to...
 

Yo,


Props to Tesla042 for this procedure:

http://haxx0r.net/car/rx7/oil_ring/

I replaced the o-rings, they were more like gaskets when I pulled them out: squashed flat.

The procedure was easy enough, just have a small 10mm open ended wrench, it's a tight fit in those quarters. I took longer so I could clean off all the caked oil all over everything.

I took it around the block, no leaks!

Thanks again Tesla!

KS
1989 GTUs "No more Exxon Valdez on the garage floor..."

You waited this long to do that? Shame on you! I did it the second I saw the how-to procedure. It's a good time to remove your oil pressure sending unit for a good cleaning also. This is one of those things to do when everything is running right and you are just looking for a reason to start wrenching.