Intercooler problems anyone??
 

Has anyone put the greddy 3 row FMIC on their car?
on my car its not fitting too well. Im putting the re-amemiya kit on, do you guys think i might have problems putting it on????
can i get some opinions???

a lot of FMICs need the bumper or kit to be cut to fit it, but if you can do it right, it looks pretty badass. if you do have to cut anything, take it easy, trim slowly, keep testfitting and youll be fine

and for heavens sake

PICS!!!

I mount my FMIC in the front first after taking measurements of clearances from the ground and maximizing the kits opening. I then take it off measure the clearance form the frame ends were the IC was to the kit. The remainder from the first measure meant is how much you need to trim. I then mount the bumper and unmount it. Then mount the FMIC and tape markers on the ends of it. Place kit over allowing markers to give my cut point. I check these against my measurements and trim less then my remainder figure. I test fit and proceed slowly from here till the fit is right.

:-D

You do realize that you NEED to cut the car up, right?


-Ted