How hard is it to remove....
How hard is it to remove a Turbo and manifold from a 1990 Rx7 turbo.
I was wondering if I could save myself some money by doing it myself but if its to difficult ill just bring it to a shop. Thanks Joe |
Not to hard.. my friend SLOWT2 says its actualy harder to remove the heatshild than to do anything else
|
Any one know what tools ill need?
and a guess on how long it will take? |
a few hours i think. yes the heatshield is the hardest part. i just cut mine off with a dremel. im not sure what sockets youll need. prolly just a good metric socket set.
|
Get a Haynes manual.
You'll need a standard socket set with metric sockets. LOTS of WD-40, and perhaps new gaskets for installation. |
gecko7 if u need help.. give me a shout... i have never done nor do i have an idea how to do it... but hte FSM is god and i'm sure 2 people with an FSM and a telephone will figure it out.
|
When I installed my DP the hardest part was getting to the bolts. I also sprayed some liquid wrench stuff on for like a half hour and it helped alot.
|
Thanks for all the replies
Cheers Ill definetly give you a call man Thanks. |
gecko... did i mention there is a time limit to my offer... i'm heading back to kingston for 8 months for school again... so u have to let me know before august is over
|
i beleive u will need a 14mm socket...its tough if u still have the heat shield on, as everyone else has said. the bottom one, i used a wrench to get that off. the two top one, i used the rachet with a 2 inch extension. it also helps if u have small hands...(one of those times when u wished u had girly hands..kekekek).
good luck, ut |
All times are GMT -5. The time now is 05:07 PM. |
© 2024 MH Sub I, LLC dba Internet Brands