HELP info needed on torque spec!
 

I'm replacing a spindle assembly, and I need to know what the specs are for how much torque is applied to the bolt (center part of the spindle).

The knuckle and spindle is off of a T2 with ABS knuckle. Which I disassemble and replace the knuckle to my non-ABS 90 GTU, parting out the spindle and using it. Since the spindle was the part that was bent. CAUSING THE CAR TO SHAKE.

THANKS in advance guys!

I think the name of the bolt is the drive flange hub bolt... correct me if I'm wrong.

Go to : https://www.rx7club.com/2nd-generation-specific-1986-1992-17/frequently-asked-questions-2nd-generation-rx-7-faq-fc-494667/

Post #6

On this forum, teaching how to fish is always better than feeding.

ohhhh. thanks man!

DRIVE FLANGE HUB BOLTS = FT-LBS 22-25 (N-m) (29-34)

Correct me if I'm wrong guys. thanks again.