Good Lord Help-shorts Ahhhh
 

ok guys..to make the long story short...or shorter newayz,.,...i was merging on the freeway...hit the gas pretty hard in first...shifted at lik 6k to second..and motor totally dies..cant restart..pop my hood i see that my efi cop(or com i forgot) was blwon..its the 30a one..so i try to replace it with the headlight 30a since its the same..and that one blows too when i crank it...so basically i kno i have a short somewhere...i believe its gonna be connected to the ecu...couild it possibly be my shitty alarm the previous owner had installed? but the alarm still works..and all the lights will come on..just wont start..ne1 have this ever happen? please help
thanks guys o yea this is a 1988 tii

check the wiring/harness that goes to the fuel injectors

Dude, shorts = suck.

Like I told someone else, there are really only 2 ways to find a short.

Method one: Get a schematic and start tracing out from the fuse. Check wires, plugs, etc... This is the preferred method.

Method two: Stick a solid peice of wire in the fuse location, look for smoke. Smoke=short. Now if your fuel pump is causing your problem, this will result in an exploded car. Not the method I prefer nor advocate, but I have used it sucessfully in the past.

I would highly suggest getting friendly with the wiring diagrams..Or wait for HAILERS, he sleeps with those diagrams.

Jarrett

Used this method to find that I fried my starter and the starter lead wires.

Re: Good Lord Help-shorts Ahhhh
 

If the fuse only blows when you crank the engine (not when the key is in the "ON" position) then I'd look at the starter motor wires first. Follow them from the battery all the way down to the starter, and inspect the starter. If one of those starter leads is loose or missing some insulation, it will cause a problem.

Did the car crank at all when you turned the key, or did it just blow right away?

it did crank and i think ui heard the starter..and i am actually not sure exactly when the fuse would blow..it make have blown with the key just on the on position..
thanks

if the i can hear the starter does that mean that it can still be a possibility?

aite guys..heres the update...the starter works..i yanked my fuel pump and its not deliversing fuel in the on position..which i believe it should correct? so its somewhere tied to the egi comp fues under the hood and the fuel pump..any i deas where to start looking? im thinkin a relay but not sure.

any relays to suggest i check?

ok guys well..i found another problem..it seems that my o2 sensor plug was disconnected from the wire..the wire may have hit a ground and shorted..but i cant believe that that little wire would burn a 30 amp fuse...i am going to check the fuel pum presistor and relay tonite with a voltmeter..any suggestions would be greatly apprecitaed.

Fuel pump wont pump in the on position unless you cross the little primer harness (think it's yellow) by the air filter. Can't really offer more...

what do you mean my cross? and i if it is on the on position shouldnt it be feeding fuel...not necessarily be pumping to but still feeding fuel? becaus i actually yanked the feed line off the fuel pump and nothing was coming out on the on position.