RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   getting annoyed startup (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/getting-annoyed-startup-385352/)

bigturbo 01-13-05 09:59 AM

getting annoyed startup
 
Ok so about once a week at random my car wont start after going in and out of a store after getting it up to operating temp. Its an 87 T2 and I replaced the o2 plug wires, plugs oil and battery with an optima red top. It normally takes about 4-5 times turning over before it starts even when cold(sometimes only twice its sparatic(sp?). Ill go into a gas station and fill up or go into the grocery store come out and it will not start. I have to get out push the car and pop the clutch to get it started then it will work fine for a week. My only current mods are turbo timer, 3 inch exhaust, 10 mm plug wires, ngk plugs, intake filter. It has done this since about the second week I owned it and only happens once or twice a week. I run a few bottle of lucus fuel system cleaner about once a month and use 93 octane most of the time otherwise 91. It idles normally all the time except every once in a while it will bounce around between 400 and 700 but then once I drive off and get up to cruising speeds it will go back to normal. that only happens maybe once every two weeks. What else should i do. I have an safcII that will be here tomm and I wonder if maybe i can get that to let less fuel in or something??? After cranking 10-12 times I can smell fuel but thats because its flooded at that point. Could it be injectors, starter, grounding to batt, or maybe something like a crame cams HI 6 would help gett better spark. I dont know. All I know is its really getting old especially in winter. :(

assman20a 01-13-05 10:14 AM

i would go with changing/replaceing/or cleaning the injectors, because it sounds like its floding right away

bigturbo 01-13-05 10:34 AM

Thats what im thinking. i am replacing the sec with greddys 720s but maybe I should replace the main ones too. is there anywhere to get a cheap set of primary low impedance new injectors. If mine only have 100k and are clogged/ruined then I am sure that used ones may not be any help. Anyone else? Keep the ideas coming. thanks


All times are GMT -5. The time now is 08:39 PM.


© 2024 MH Sub I, LLC dba Internet Brands