fuel rail and banjo bolt question.
 

http://www.unrealweb.net/RX7/fuelrail.jpg

one end of B is deep and one end isnt. wich way faces the banjo bolt, the deep end or not? and wich washers go between A & B.. and B & C? i was too excited that i forgot when i got it apart (it was VERY hard to get the PD off). thanks.

don't you have to use another one of those curved fittings intead of that straight one you have to eliminate the pd?

big washer goes under the head of bolt and of course is there for bigger opening in fitting....
just by looking at it should be obvious

anything go between B & A? and does the deep end of B face A?

bump

geez bump

small washer

bigger washer is on outside, bigger washer is for bigger opening

thanks higgi