Fried a sensor on the emissions equip??
 

Yeah, so this went up in smoke the other day-
Whats it do?
http://www.iupload.net/042004/rx7fried.JPG

that's your port air solenoid valve- it shouldn't have had any voltage going to it unless your 20K mile switch was screwed (should be no prob with it out of service)

Haha, how did that thing get toasted anyways?

My coolant fill necks plastic cracked and leaked antifreeze on it, went up in smoke, toasted the wires right off it.

Ok to leave it then?

Unless your car is under 20K miles, do not worry about it.

90k on this motor, 225k on the body

I thought it was 9k on the motor??

Ive told ya 3 times now.
Lay off the cronic! :lol:
:p:

So is it 9 or 90?

Humm, damn that cronic! I swear to dog that you said 9k when you first got it..

You bunch of Oregon peoples. Cracked out on drugs all the time. :p:

No, not quite right. It always has 12v going to it on the black/white wire. These solenoids work by having a ground put on them by the ECU. That Port Air Solenoid is disabled at 20,000 miles by the ECU not putting a ground on it anymore after that figure. The black/white wire will always have 12v on it.

I'd suspect that the harness has been twisted and abused at where it enters the sensor and finally the black/white touched a ground *somewhere*.

Since the Port Air Solenoid is not used after 20,000 miles....then just disconnect the plug for it and tie it back.