FMIC.. Help Please...
 

Does anyone have the piping sizes (length) used in your fabbed fmic setup?.. if you have angles that would be nice too :) also what size of intercooler would you suggest i use using the stock turbo setup? (i dont want to use the tmic due to its condition, and also the fact i do not have a t2 hood).. thankyou in advance.

Clint

View my blog. I ran 3in way over kill but I was planning ahead and was cheaper then stagering and I was runing low on $.

i went 2 inch wishing i did 2 1/2..... mine is a 6 port turbo also so my bends are different. i used exhaust piping that wasnt manderel bent for quick setup reasons due to the winter creeping up on me... this summer ill rip it out take some of them to a muffler shop with some of them connected by coouplers and have them bend it to eliminate the couplers... maybe find a dif. route..

thanks for the blog iceblue, it gives me an idea.. i have a turbo motor though so , i suppose it would alter.. basically iam hoping someone by chance would know the sizing of the piping and degrees of the bends in comparison to the greddy kit..

2 1/4 for the hot side, 2.5 for the cold side.

Mine was on a turbo motor with full luxury left on it. You can rought 2.5 through the hole between the PS and AC but not 3in so I got creative.